Hi, Been running my palette 3 pro for a few weeks now, and I keep having the trouble of being gone for a while and come home to a failed print that is till printing or has stopped all together. Will canvas be able to have an app or something that allows for remote monitoring like obico for octoprint anytime soon? I have my camera linked to my laptop for monitoring from home, but I'd like to keep a check on my long prints while I'm gone to work and such. Any information will be very helpful!

Thank you,

Cody Parris

I am trying but I am really struggling with Canvas. It is missing so many critical splicing features that Cura and Simplify3d have had for years and my print quality is really suffering. To be candid the only thing I have really been able to successfully print was the keychain. My finish quality of PETg prints is so much worse then when I did the same prints with S3D, Chroma and P2S, I am having to use rafts and higher temps because of the lack of first layer settings. Canvas feels like a huge step backwards.

Can we please have Chroma for the P3Pro?

Thanks!

Ok, this is weird but is slowing my prints to a stop. When the printer is painting the transition bock it goes normal for about half of it then it moves so slow you can barely see it creating an ironed line perpendicular to the long side of the block. then it goes back to normal speed on the print and then does the same thing over. The only thing I saw was side transition was set at 4mm however, I am not using that. I am on a voron 2.4 using a P3P in accessory mode. any thoughts? Transition speed is test to 80mm/sec

I do a lot of prints without the purge block. i.e., colour change at height and random mode. I’m getting under extrusion at the colour change. Everything else works absolutely great so I’m wondering if it could be a splice tuning issue? I also had a note pop up saying my splice tube is old and should be changed but I wasn’t experiencing any problems at the time so ignored it. Could this also be a contribution? Obviously when I’m using a purge block under extrusion and the splice isn’t a problem, but a hole in the print at the colour change is!

Cheers

Matt

I've been having issues with my p3p where the spliced filament is inconsistent in diameter casuing failed prints, I've done way to much splice tunning and created new material profiles and it's always the same... The print starts fine but after a while the diameter is to much to pass through the extruder (1.9-2.0 mm) I checked my splice core to see if it was damaged... I think it's ok but I need to confirm if it is in fact fine

using a Palette 3 Pro.

I'm having difficulty arranging my prints to be centered on the print plate. I've used two different printers (Creator Pro and Flashforge Inventor 2).

I've adjusted the bed profiles to both printer prints with the front left or the center as the origin. Each time I make the adjustment, the prints continue to be done in the back right.

I'm assuming this is a slicing issue that can easily be fixed by someone (not me) with g-code knowledge.

What changes can I make in Canvas to allow me to print in the center of the bed rather than the back right corner?