This guide is hidden from normal users because there is no published Release.
v1.1
Minor Versionm
08/13/2020 by Adalyn Ordono
Difficulty
Moderate
Steps
6
Time Required
00:15:00 - 00:25:00
Sections
1
This installion uses the 1.75mm Adaptor A
How to replace the Ultimaker bowden tube with the PTFE tube used for 1.75mm filament.
How to install the short hot-end PTFE sleeve into the hot-end.
How to swap the extruder drive arm in the Ultimaker filament feeder on the back of the printer.
Install the Palette outgoing tube into the filament feeder or extruder input.
Run a test print using 1.75mm filament to see if the adaptor installation is done correctly.
Please proceed to the calibration guide.
Cancel: I did not complete this guide.
Member since: 3/31/20
9 Guides authored
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.
© 2025 Mosaic Manufacturing Ltd.
