Introduction
Variable Transition Lengths are useful for prints when you're using filaments that are very different from each other—like the black and white filaments in this penguin print.
When this happens, it's ideal to have a longer length to transition from black to white as the black filament could easily bleed into the white portions of the print. However, the transition from white to black could be shorter as this causes less chance of bleeding. Variable transition lengths help to reduce colour bleed by optimizing transition lengths for each filament.
-
-
Turn on Advanced Settings in Chroma by going to Tools > Preferences > Enable Advanced settings.
-
Go to the Transitions tab in your Printer Profile to set a Min and Max Transition Length.
-
On Chroma's main screen where you select the drive colors, you'll notice a slider which allows you to select each color's pigment strength. The transition length that is used between these filaments will be adjusted based on the two colors' strengths.
-
If you have any additional questions about how to use Variable Transition Lengths, please send a message to support@mosaicmfg.com.
If you have any additional questions about how to use Variable Transition Lengths, please send a message to support@mosaicmfg.com.
Cancel: I did not complete this guide.
3 other people completed this guide.
2 Comments
Hey @hal, transition in infill is a project setting in CANVAS that allows some of the transitions to be done within the infill of your model. This is a great option if you want to save some filament (mm3d.co/filament-waste). In terms of supports, the article for supports in CANVAS can be found here, where we go over basic, custom, and soluble supports: mm3d.co/supports-in-canvas
Hope that helps and please let us know if you have any further questions!
I found it. I must have completely skipped over the last informational box
Jonathan Zimmers - Reply
No problem Jonathan, please let us know if you have any other questions about these steps.
Alina -
This is a helpful guide, but I have a question about the setting. What determines a color’s “strength” as referenced in this statement, “The transition length that is used between these filaments will be adjusted based on the two colors' strengths.”
Jonathan Zimmers - Reply