Introduction
In this guide you will learn how to remove the connector from the Pi and reseat it in your Palette 3/3 Pro
Tools
Parts
No parts specified.
-
-
Remove Palette's top lid.
-
Using the provided Torx screwdriver, remove the 4 screws on each corner of the substructure.
-
-
-
Remove the IO plate cover from the unit, by pulling the tab on the Ethernet port. The IO plate cover is snap-fit to the unit and can be placed back easily.
-
Gently lift and remove the substructure from the bottom casing.
-
You'll now be able to replace the main board, fans, and other components.
-
-
-
Locate the Pi(CM3+ Raspberry Pi Compute Module 3+)
-
The Pi is the green board in the bottom left hand corner
-
-
-
Remove the Pi by lifting it out of the casing
-
Open the two metal fasteners on each side of the Pi to lift it out of the casing
-
Place the Pi back into the casing and clicking it into place using the two metal fasteners on each side
-
If you have any additional questions, please send us a message at support@mosaicmfg.com.
If you have any additional questions, please send us a message at support@mosaicmfg.com.
Cancel: I did not complete this guide.
One other person completed this guide.
