Video Overview
-
-
Remove Palette's top lid.
-
Remove the 4 thumbscrews from the buffer area and remove the acrylic cover.
-
-
-
Remove the PTFE tube from fasteners and lift the collet before removing the entire buffer tube along with the brass retainer.
-
-
-
Install the collet onto the new PTFE tube and then the brass retainer.
-
Place the brass retainer end into the gap by the outgoing drive. Reinstall the collet and slowly re-align the tube into the grooved and fastened areas. Snap the tube back into place, following along the buffer area and towards the scroll wheel.
-
Replace the acrylic cover, thumbscrews, and top lid.
-
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
4 Comments
You may wish to tell how long the tube is so that others can replace the tube via cutting a new one if needed as it's a pain to measure accurately an would save many frustrations as I am pretty sure that tubes length is part of the palette's system on when to hit the switches for its timing an measuring an would throw it off it the wrong length was used.
The buffer tube is the same length as the short outgoing tube, which is ~57 cm.
I need a collet and a brass fitting where do I order them?
Hey there, we have them available on our Spare Parts store: mm3d.co/spare-parts
If you’re having any trouble, please contact us at support@mosaicmfg.com
