Introduction
At the top of each Storage Cart is a designated area for 40 empty print beds. This area is broken down into four zones labelled A through D. Each zone should contain only one type of print bed.
-
-
Prepare beds for loading - each zone of the bed feeder must only hold one type of bed
-
Ensure all prints, skirts, materials and residue are removed from all print beds
-
If using glue for bed adhesion, avoid stacking beds to prevent glue from being transferred to bottom of beds.
-
-
-
Starting from the bottom (slot 1) of Zone A, load one print bed through the grating until it cannot be pushed further back
-
Continue loading print beds of the same type moving upwards in Zone A (slot 2, then 3 and so on)
-
If you have more than 10 beds of the first bed type to load, continue to Zone B - Slot 1, then continue to fill Zone B
-
-
-
Once you have finished loading all of the first type of bed, load the second type of beds into the next empty Zone, starting from slot 1
-
Continue loading beds, starting with the lower numbered slots
-
If you have any additional questions, please send us a message at support@mosaicmfg.com
If you have any additional questions, please send us a message at support@mosaicmfg.com
Team
