Guides
Slicing
Palette supports four slicing programs, Cura,...
Ultimaker 2+, 2+ EXT - Adaptor Setup
How to install the 1.75mm Adaptor (A) with Ultimaker 2 and 2+ EXT
Ultimaker 2+, 2+ EXT - Calibration Guide
If you're not printing with a Palette, please...
Ultimaker 2, 2Go - Adaptor Setup
How to install the 1.75mm Adaptor (B) with Ultimaker 2 and Ultimaker 2Go.
Ultimaker 2, 2Go - Calibration Guide
If you're not printing with a Palette, please...
Ultimaker 3, 3 EXT - Calibration Guide
If you're not printing with a Palette, please...
Ultimaker S3, S5 - Adaptor C Setup
This installion uses the 1.75mm Adaptor C
Ultimaker S3, S5 - Calibration Guide
If you're not printing with a Palette, please s...
Screen Not Powering On - Firmware Troubleshooting (S Series)
This article assumes that you have already...
Multi-Spool Mode
Multi-spool mode allows users to splice spools of filament together or to...