You may wish to tell how long the tube is so that others can replace the tube via cutting a new one if needed as it's a pain to measure accurately an would save many frustrations as I am pretty sure that tubes length is part of the palette's system on when to hit the switches for its timing an measuring an would throw it off it the wrong length was used.
So far looks like they was going to put in a recalibrate for the pro 3 yet so far has yet to be done with its most recent update in 22 here we go to 23 will we see a way to recalibrate on the pro3 as well as have a feed control so one can feed out the filament from the paette as to reach siad filament so we can grab it. I know its supose to be done via the machine but really if your print is too small there is no way to grab it as its stuck inside of the palette an you cannot get too it unless you remove its cover an take out the filament from there!
Why are there no jog controls so that one can simply make the palette push the filament in it out so you can reach it? They don't allow you to do it via palette or the on-screen mode if in connected mode. What a waste of time money an filament trying to get this all figured an set up when all they needed was this to do a simple thing!!!
You may wish to tell how long the tube is so that others can replace the tube via cutting a new one if needed as it's a pain to measure accurately an would save many frustrations as I am pretty sure that tubes length is part of the palette's system on when to hit the switches for its timing an measuring an would throw it off it the wrong length was used.
error code 403? where is that on here?
So far looks like they was going to put in a recalibrate for the pro 3 yet so far has yet to be done with its most recent update in 22 here we go to 23 will we see a way to recalibrate on the pro3 as well as have a feed control so one can feed out the filament from the paette as to reach siad filament so we can grab it. I know its supose to be done via the machine but really if your print is too small there is no way to grab it as its stuck inside of the palette an you cannot get too it unless you remove its cover an take out the filament from there!
Where exactly is this at anymore?! It is not on the palette is it on the canvas screen to do this?!
Why are there no jog controls so that one can simply make the palette push the filament in it out so you can reach it? They don't allow you to do it via palette or the on-screen mode if in connected mode. What a waste of time money an filament trying to get this all figured an set up when all they needed was this to do a simple thing!!!
Smart load dont work! Still filament inside of palette.