What do you mean by, messed up? Like the colors are in the wrong shots or there is significant bleed?
What I did for the black to white transition is add a white block to my Print for extra transition space. It's not the most economic way to do it, but just using the transition tower at max length was not enough. So I lowered it to 250. It works wonderfully now.
Is there a difference in the Value of the LO here and the value of the LO in the printer settings in Canvas?
I have been having an issue that no matter what length I put in the LO, the Smart Load is always off by the same amount.
The reason I have this issue, I believe, is that I am using the Ender 3 Max, which has a Filament Runout Sensor. Because of this, I have to pull some filament out after it is primed for the smart Load to feed it past the sensor, and that is the amount of filament that the print is off by.
I have noticed that sometimes, the filament that is pushed past the Out Going Tube length is longer than normal (normal being just long enough to fit an ender 3 which is the profile I am using and modified for the Ender 3 Max) and actually fits through the filament run out sensor, but it is still not long enough to hit the nozzle at the end.
I have an ender 3 max that came with a filament sensor installed. Is there a way to extend the initial amount of filament out to allow for the extra distance?
It happened once or twice by itself, but I don’t know if or where the setting it.
Also, I can’t tell if increasing the bowden tube length matters as the Smart Extrude is always short, probably by the length of the filament sensor
What do you mean by, messed up? Like the colors are in the wrong shots or there is significant bleed?
What I did for the black to white transition is add a white block to my Print for extra transition space. It's not the most economic way to do it, but just using the transition tower at max length was not enough. So I lowered it to 250. It works wonderfully now.
Is there a difference in the Value of the LO here and the value of the LO in the printer settings in Canvas?
I have been having an issue that no matter what length I put in the LO, the Smart Load is always off by the same amount.
The reason I have this issue, I believe, is that I am using the Ender 3 Max, which has a Filament Runout Sensor. Because of this, I have to pull some filament out after it is primed for the smart Load to feed it past the sensor, and that is the amount of filament that the print is off by.
I have noticed that sometimes, the filament that is pushed past the Out Going Tube length is longer than normal (normal being just long enough to fit an ender 3 which is the profile I am using and modified for the Ender 3 Max) and actually fits through the filament run out sensor, but it is still not long enough to hit the nozzle at the end.
What am i doing wrong? Is there a fix?
I have an ender 3 max that came with a filament sensor installed. Is there a way to extend the initial amount of filament out to allow for the extra distance?
It happened once or twice by itself, but I don’t know if or where the setting it.
Also, I can’t tell if increasing the bowden tube length matters as the Smart Extrude is always short, probably by the length of the filament sensor
is there going to be a calibration tool or print that can help with this? Something made by Mosaic? Would be fun.