mykeone

Splice core has a pin that does not pop out when the splice core is removed.. does it need a new splice core

Palette 3 pro splice failures. What is the best way to troubleshoot the splice core... https://youtu.be/5POAjMVydts?si=IF1S7OXO... it does not heat correctly..

has anybody had any luck getting a palette 2 to work with a k1 max. i have follower all the steps but it still gets errors. at this point i am just asking to see if anybody has actually gotten it working.. they say it works but nobody has proven it...

has anybody actually gotten a k1 max to work with a palette 2. yes there are steps but has anybody seen the setup working. this site says the k1 max works but nobody in the wild can be located with it working.

Where are the steps to make the palette 2s work with a creality k1 max...

Nobody has the steps to make it work in connected mode on a k1...

i am using a K1 max

Is Klipper compatible?

Yes, Klipper is compatible for Palette 2 in connected mode.

Is there anymore information on how to get the palette 2 connected to klipper. I have followed all the steps in the given link and it is not working but does connect.

can you please share a link to the Encoder PCB. i followed all the steps and that is the only thing left... palette 2 pro showed that i need to feed 17000mm more into the extruder.