Introduction
The following webcam package plugin can be used with CANVAS Hub S.
-
-
Use the to install the plugin (if it is not already installed): https://gitlab.com/mosaic-mfg/webcam-pac...
-
Go to Settings > Plugin Manager > Get More > ...from URL.
-
Restart OctoPrint once the plugin is successfully installed.
-
-
-
Go to the Webcam Package tab, and click Install Package.
-
This may take between 5-15 minutes.
-
Plug in your webcam and restart the CANVAS Hub by going to System > Restart OctoPrint.
-
Return to the Webcam Package tab, you should now see Configuration Settings available. Please refer to this guide on compatible webcams for OctoPrint.
-
Once you identify your webcam, enter its resolution settings, desired frame rate, and quality into the configuration. Please save your settings.
-
Go to the Control tab, here you should now see the output for the webcam display.
-
-
-
Settings are Overridden
-
Manual configuration is available for advanced camera settings. Entering a manual configuration into the field will override the configuration settings outlined in step 4.
-
Webcam Stream is Not Displaying in Control Tab
-
Check that the configuration settings match the webcam, and remember to click Save Settings in the Webcam Package plugin.
-
Check that the webcam is connected to CANVAS Hub S.
-
Reboot CANVAS Hub by going to System > Reboot, or hard refresh the web page.
-
Installing OctoLapse
-
To install OctoLapse, please follow the steps here.
-
If you have any additional questions, please send us a message at support@mosaicmfg.com.
If you have any additional questions, please send us a message at support@mosaicmfg.com.
