Skip to main content

v1.1

Minor Versionm

by Adalyn Ordono

Introduction

This article assumes that you have already attempted to update the firmware using the Firmware Updater and your unit's screen does not power on. If you have not done so already, please follow the steps in this support article before proceeding with the step below.

Please note: The steps below are only necessary if the screen is not powering on with the power cable connected and you are not receiving a response from the Firmware Updater.

Tools

Parts

No parts specified.

  1. Turn Palette 2 off and remove the top lid by gently lifting from the sides. Remove the splice core by unscrewing the thumbscrew and lifting the splice core from the substructure.
    • Turn Palette 2 off and remove the top lid by gently lifting from the sides.

    • Remove the splice core by unscrewing the thumbscrew and lifting the splice core from the substructure.

  2. Check that the power supply and USB cable from your computer is plugged into Hold the reset button for about 10 seconds, then turn the power switch on. Once Palette is on (you will see light emit from the homing switch and from within the unit), wait approximately 5 seconds and then release the reset button. The screen itself may remain off and dim.
    • Check that the power supply and USB cable from your computer is plugged into

    • Hold the reset button for about 10 seconds, then turn the power switch on. Once Palette is on (you will see light emit from the homing switch and from within the unit), wait approximately 5 seconds and then release the reset button. The screen itself may remain off and dim.

  3. Launch the Firmware Updater program. Click Advanced Options and the refresh button. Click the ports list to see if you have a manual port available, if so select the port (not Auto) and that 'Hardware Bootloader' is selected. Click Screen and upload the file 'P2EE02.bin' from the zip file (Firmware version 9.2.9)
    • Launch the Firmware Updater program. Click Advanced Options and the refresh button. Click the ports list to see if you have a manual port available, if so select the port (not Auto) and that 'Hardware Bootloader' is selected. Click Screen and upload the file 'P2EE02.bin' from the zip file (Firmware version 9.2.9)

    • The progress bar should now appear. Once the screen firmware has been updated successfully, you will see the screen turn back on.

    • Return to Advanced Options, and ensure the proper port is selected. Select Main and upload file 'P2EE01.bin from the unzip file.

    • Once this is uploaded, return to Advanced Options and select the proper port. Once done, select Graphics and upload the file 'ui.min' from the zip file.

    • You're all updated! Please re-assemble Palette 2S (Pro).

Conclusion

If you have any additional questions, please contact us at support@mosaicmfg.com.

Adalyn Ordono

Member since: 03/31/2020

3,713 Reputation

9 Guides authored

Team

Customer Success Member of Customer Success

Community

4 Members

12 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 5

Past 30 Days: 31

All Time: 48

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.