Skip to main content

v1.2

Minor Versionm

by Guy Elston

  1. Allow the hotend to cool down completely to room temperature. On the touchscreen, tap 'More' and select 'Disable Motors'. Gently slide the printhead manually to the center of the gantry where you can easily reach the nozzle.
    • Allow the hotend to cool down completely to room temperature. On the touchscreen, tap 'More' and select 'Disable Motors'.

    • Gently slide the printhead manually to the center of the gantry where you can easily reach the nozzle.

    • Peel off the black silicone sock from the bottom of the heater block.

  2. On the touchscreen, heat the nozzle to 290°C.
    • On the touchscreen, heat the nozzle to 290°C.

    • Always heat the nozzle before unscrewing to soften trapped plastic and prevent thread damage.

    • Hold the heater block steady with the provided wrench so it does not twist. Use the official socket nozzle tool to unscrew the hot nozzle counter-clockwise.

    • Place the hot nozzle onto a heat-safe surface on the bed to cool down.

    • Set the noozle temp to 0°C and wait for the screen to indicate it has returned to room temperature.

    • Insert a new nozzle, leaving it loose. Heat the nozzle to 290°C.

    • Once temperature is reached, hold the heater block with your wrench and tighten the new nozzle clockwise with the socket tool, until it is snug.

    • Set the nozzle temperature to 0°C. Allow the assembly to cool down, then reinstall the silicone sock with the cutout notch facing front. If the sock is installed backwards, it will affect the levelling process.

Finish Line

Mosaic Support

Member since: 4/2/20

167 Guides authored

Contact Mosaic Support Team

support@mosaicmfg.com

+1 (647) 254-1773

© 2025 Mosaic Manufacturing Ltd.