Skip to main content

v1.0

Major VersionM

by Guy Elston

  1. The part ejector sits at the front roller to gently peel finished insoles off the conveyor belt as it rolls forward.
    • The part ejector sits at the front roller to gently peel finished insoles off the conveyor belt as it rolls forward.

    • Proper alignment requires a tiny gap—about 0.2 mm, or the thickness of standard cardstock—between the blade edge and the textured belt surface.

    • If the blade touches the belt directly, it can scratch the print surface; if the gap is too large, parts may slide under the blade instead of releasing.

  2. Take a clean strip of cardstock paper (roughly 0.2 mm thick) and slide it flat between the plastic ejector blade and the belt. Locate the two silver bolts on the blade mount bracket holding it to the front aluminum beam, and the two silver bolts underneath the bracket. To access the bolts underneath, it can be helpful to slide the printer forward, so the front few inches are hanging over the end of your table.
    • Take a clean strip of cardstock paper (roughly 0.2 mm thick) and slide it flat between the plastic ejector blade and the belt.

    • Locate the two silver bolts on the blade mount bracket holding it to the front aluminum beam, and the two silver bolts underneath the bracket.

    • To access the bolts underneath, it can be helpful to slide the printer forward, so the front few inches are hanging over the end of your table.

    • Use your 2.5 mm Allen key to loosen all bolts by one to two turns so the blade mount slides freely. Do not fully remove the bolts.

  3. Gently press the plastic blade assembly until the entire bottom edge rests evenly against the cardstock. Check that the blade mount is resting flush against the lower aluminum frame tabs on both left and right sides.
    • Gently press the plastic blade assembly until the entire bottom edge rests evenly against the cardstock.

    • Check that the blade mount is resting flush against the lower aluminum frame tabs on both left and right sides.

    • Make sure you apply even downward pressure across the whole bar so one side is not tilted closer than the other.

  4. Hold the blade in place and tighten both button head screws until snug.
    • Hold the blade in place and tighten both button head screws until snug.

    • Slide the cardstock out; you should feel slight drag, but the paper should pull free cleanly without tearing.

    • Run a test belt cycle by navigating to Calibration & Tools > Cycle Belt on screen. If the blade leaves any faint scraping marks on the belt, slightly raise the blade and re-tighten.

Finish Line

Mosaic Support

Member since: 4/2/20

167 Guides authored

Contact Mosaic Support Team

support@mosaicmfg.com

+1 (647) 254-1773

© 2025 Mosaic Manufacturing Ltd.