Skip to main content

V1.2

Minor Versionm

by Jonny Yeu

Introduction

Palette's Change Filament feature further extends your printer's capabilities. You can now pause a print and swap filament from your Palette's inputs. This allows you to swap a spool of filament that is about to run out, or even add more than 4 colors to your print!

  1. During a print, press the menu button and choose ‘Change Filament’. From here, you’ll be able to choose which filament inputs you would like to change. Palette will unload the selected inputs and give you an opportunity to replace them with new spools.
    • During a print, press the menu button and choose ‘Change Filament’. From here, you’ll be able to choose which filament inputs you would like to change. Palette will unload the selected inputs and give you an opportunity to replace them with new spools.

    • It’s important to pause your print if you are running in Accessory Mode. In Connected Mode, this will happen automatically.

    • As an added bonus, ‘Change Filament’ can also help create prints with more than 4 colors. If one color is only used early in a print, but a 5th color is needed later, then these colors can be swapped.

    • Set up your print in your slicer so both of these parts use the same input. Then, once the first color is done printing, swap the spools using the process discussed above, just make sure you do this before the next color is needed.

Conclusion

If you have any additional questions, please send us a message at support@mosaicmfg.com.

4 other people completed this guide.

Mosaic Support

Member since: 04/02/2020

155 Guides authored

Contact Mosaic Support Team

© 2024 Mosaic Manufacturing Ltd.