Avatar

Joe Bruno

  • Total activity 18
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 7

Activity overview

Latest activity by Joe Bruno
  • Avatar

    Joe Bruno commented,

    How do you get past the wizard? I have a P2 and downloaded Chroma but if you dont complete the wizard which appears to be applicable to the original Palette the program exits.

  • Avatar

    Joe Bruno commented,

    I'd like to know this too. I just installed a new extruder BMG on my Prusa. I used a jig that uses a digital caliper to meausre in real time how much filament is fed into the extruder when calibrat...

  • Avatar

    Joe Bruno commented,

    Can we get more info/examples here? If I wanted to create a smooth gradient where there were less noticeable bands of single colors, what would the numbers look like? You guys had a yellow and blue...

  • Avatar

    Joe Bruno commented,

    A pause would be nice .Then all I would need to do is figure out a good way to have my mk2 and octoprint act accordingly. Havent tried in a while but the last time I used the prusa pause commands I...

  • Avatar

    Joe Bruno commented,

    I may have tried Canvas and Chroma as I'm still experimenting. I believe the last print that triggered the wizard was initiated via Chroma to Octoprint to the P2P. Just still trying to wrap my head...

  • Avatar

    Joe Bruno created a post,

    Printer profiles. What are they?

    I have 3 profiles on my Palette 2 Pro. I'm not sure what they're used for and why there are 3 whereas I only have one printer. Last night after 2 days of successful prints I was prompted by the new...

  • Avatar

    Joe Bruno commented,

    Is it possible to have a longer length of filament extending out of the tube when starting prints? Depending on your clip mounting setup it would be helpful if there was more filament to hold onto ...

  • Avatar

    Joe Bruno commented,

    Also, while we're on the subject, why not have multispool support filament runout. It detected that the small strand I had loaded into slot 1 run out and it spliced to slot 2 but why not eject slot...

  • Avatar

    Joe Bruno created a post,

    Potential Bug with Multi-Spool

    Loaded a few strands of filament in position 1 and 2. P2P connected to Octoprint. Sliced with Prusa Slic3r. The screen on the P2P said to start the print. I started the print and while it was print...

  • Avatar

    Joe Bruno commented,

    Wonderful. Thanks for acknowledging