Avatar

Paul McMaster

  • Total activity 10
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 1
  • Subscriptions 4

Activity overview

Latest activity by Paul McMaster
  • Avatar

    Paul McMaster commented,

    Hey joelito, I have printed a single color and I does not do the gaps. Also the infill overlap for the rest of the print is good so I'm not sure that is the answer but I will give it a try and repo...

  • Avatar

    Paul McMaster created a post,

    Infill on small color areas using canvas with p2p

    I am printing some signs where the lettering is inside a plate. The plate seems to print fine but the letters not fully filled in and lines don't always touch. https://drive.google.com/file/d/1fCvp...

  • Avatar

    Paul McMaster commented,

    I'm also experiencing the slicing of the bottom problem, and the no pings. I run connected mode on a cr10

  • Avatar

    Paul McMaster created a post,

    end of filament too short

    My second print attempt went much better as far as color separations is concerned but one of my issues now is that the filament was too short at the end so near the end of the print it got to the p...

  • Avatar

    Paul McMaster created a post,

    wrong colors

    I am trying to print the mosaic keychain as my first print. it's almost perfect on my second try as far as color separations go but one problem I am having is the colors are in the wrong spots. It'...