
Manmeet S
- Total activity 37
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 22
Activity overview
Latest activity by Manmeet S-
Manmeet S commented,
Hey Ramon! I noticed from previous posts that you were printing at 80 mm/sec. I understand that you print the outlines at 50% of this speed however I think what might be happening is that your Pale...
-
Manmeet S created an article,
CANVAS Hub Factory Reset
In the rare case that your CANVAS Hub cannot be seen while broadcasting its built-in WiFi hotspot, please follow the instructions below. The following steps will reset the code found on your CANVAS...
-
Manmeet S commented,
Thank you for the feedback Roger M and Wmmc01 both suggestions/fixes should now be reflected in the updated article.
-
Manmeet S created a post,
2018.12.18 Palette 2 (Pro), CANVAS Hub update: (1) getting set up, (2) high-priority bugs, (3) Palette 2 setup live stream
(Cross post from our Facebook user group for all of our non-facebook users) Hi Everyone, It’s been a few weeks since Palette 2s started arriving at everyone’s homes and we are very happy to see al...
-
Manmeet S commented,
Hey Ray, Super happy to hear that your back in business and your prints are on calibration. In terms of the Duet3D I agree its a great piece of hardware but could you give me more of an idea of wha...
-
Manmeet S commented,
Each one of the values in the ping sequence needs to be within 30% of the ideal value but yes please give that a try and get back to us!
-
Manmeet S commented,
Hey Tom, Based on your ping values they seem quite good with the exception of the missed pings of course. A ping is detected when a particular sequence of gcode occurs: a 13-second pause, 20mm of e...
-
Manmeet S commented,
Hey Tom, That is definitely odd behavior, let me speak to the software team about this and get back to you!
-
Manmeet S created an article,
Setup Guide: CANVAS Hub
What does CANVAS Hub do and why does it need to be setup? CANVAS Hub is the keystone of Mosaic’s multi-material ecosystem. It is the center of everything to do with your multi-material printing e...
-
Manmeet S commented,
I would not recommend running it from a USB hub as many USB hubs that claim they provide 5V 2A to each port only provide 5V 2A between all connected items. If the power ends up being too low your C...