Redemptioner1
- Total activity 331
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 55
- Subscriptions 88
Activity overview
Latest activity by Redemptioner1-
Redemptioner1 commented,
There should be no reason why it would not work other than you will have to spool the whole filament length through the splice core to get it back out. With an Atmega or Raspberry Pi board, a motor...
-
Redemptioner1 commented,
The hackaday article on your buffer was pretty funny to read (and rather embarrassing for the writer) how they skirted around the the reason you created the buffer and the fact it was created to re...
-
Redemptioner1 commented,
@Worker Drone 1 - This has been requested in a few variants, but is something that could resolve a lot of issues, unfortunately you can't restart a palette splice run but at least you want be wasti...
-
Redemptioner1 commented,
just to double check, you are changing this length?
-
Redemptioner1 commented,
@Raymond In Silc3r/Canvas/Chroma you need to set your bowden tube lenth (different to the setting the tube length directly on the palette). If oyour bowden tube is 1000mm long I suggest you start w...
-
Redemptioner1 commented,
The stats are pretty clear on using book-face as a support point, it results in significant additional overhead to the company compared to a forum due to the lack of search and grouping of informat...
-
Redemptioner1 commented,
I would get use to this mate, admittedly more so on the standard palette, if you try to use the P2P a lot you will deal with this constant pain of unreliability and never ending problems on a regul...
-
Redemptioner1 commented,
Technically it does not matter, as long as you don't go past the length where filament would be coming out the nozzle. So if you have say 40cm of bowden tube between extruder and hotend then you ca...
-
Redemptioner1 commented,
@Jonny And as I have said, I am happy to create the additional video and send it in, unfortunately I have not returned from overseas yet so I have not been able to physically access the pallette i...
-
Redemptioner1 commented,
@ Chris Guess you have not been part of the Slic3R community? It is night an day difference between Mosaic and Silc3r (for the better) and after using Slic3r for a couple of prints you will wonder ...