Avatar

Donovan Meyers

  • Total activity 23
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 1
  • Subscriptions 7

Activity overview

Latest activity by Donovan Meyers
  • Avatar

    Donovan Meyers commented,

    Thanks Brandon! Thought I'd lost you there. ;) I've subscribed to both issues! RE consistency, I meant from one value to the next, i.e. increasing infill percentage a tiny bit resulted in a much la...

  • Avatar

    Donovan Meyers commented,

    That's definitely very cool, and doesn't surprise me in the least. Mosaic seems like really great people. But that still leaves Gina without the hardware. Unless of course she uses the money to buy...

  • Avatar

    Donovan Meyers commented,

    With a shell thickness of 0, I get no top and bottom -- just infill. With .2 layer height and .2 shell thickness and 1 perimeter, I get one 100% solid layer top and bottom, and three 50% layers und...

  • Avatar

    Donovan Meyers commented,

    Hey Brandon, Thanks so much for your detailed response! Unfortunately for you, that just means I'll go into more detail.... - no square grid Yes, your second guess -- the directions only alternate....

  • Avatar

    Donovan Meyers commented,

    So I just sliced in Canvas with support for the first time, and noticed the "interface" settings. I set dense interface top and bottom, and noticed that it has the same behavior as the ex...

  • Avatar

    Donovan Meyers commented,

    Thanks Adalyn; can't wait to hear more soon! I sliced a print tonight with only .96mm shells (3 layers of .32) and was surprised to find that it still printed 4 extra layers of half-solid! I though...

  • Avatar

    Donovan Meyers created a post,

    Unexpected (half-?) solid layers over infill

    Hi everyone, I'm trying to slice a model with Canvas that I've always sliced in Cura. This model is weighted with 4.5mm BBs that I embed in the print by adding a pause (with OctoPrint plugin Multi ...

  • Avatar

    Donovan Meyers commented,

    Thanks for the explanation, Jonny. I'm actually not clear what "Off" will do. Does it merrily keep on trying to splice, when there's no filament to feed? I would really expect (and apprec...

  • Avatar

    Donovan Meyers commented,

    Is this limited to 4 spools/pieces? When one runs out it doesn't seem to fully unload it, nor do I see a way to reload a drive in the middle of a print. I'd like to be able to reuse 1-2m lengths of...

  • Avatar

    Donovan Meyers commented,

    Jonny, what is the best way to "try again"? The CANVAS tab doesn't have a Connect or Reconnect button like the Palette tab does. Should it automatically reconnect and update the Connectio...