Avatar

Adalyn O

  • Total activity 306
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 9
  • Subscriptions 144

Activity overview

Latest activity by Adalyn O
  • Avatar

    Adalyn O created an article,

    Filament Run-out and Back-up Drives

    Filament run-out options Run-out detection can be used in almost any of Palette’s modes. This includes calibrated multi-color, pattern, random, and gradient modes. However, the functionality is sli...

  • Avatar

    Adalyn O created an article,

    Change Filament (P2)

    Palette's Change Filament feature further extends your printer's capabilities. You can now pause a print and swap filament from your Palette's inputs. This allows you to swap a spool of filament th...

  • Avatar

    Adalyn O created an article,

    Lulzbot 1.75mm Adaptor (TAZ Pro)

    1.75mm Lulzbot Adaptor Installation Instructions Below are instructions to install the 1.75mm Lulzbot Adaptor. Please follow these 3 steps carefully and do not hesitate to contact Mosaic at support...

  • Avatar

    Adalyn O created an article,

    Lulzbot 1.75mm Adaptor (TAZ Workhorse)

    1.75mm Lulzbot Adaptor Installation Instructions Below are instructions to install the 1.75mm Lulzbot Adaptor. Please follow these 3 steps carefully and do not hesitate to contact Mosaic at support...

  • Avatar

    Adalyn O commented,

    Hi David,Can you try turning off this setting under General? This setting can help with coasters that have detailed top layers, printing as much of the same color in one direction before moving ont...

  • Avatar

    Adalyn O commented,

    Hi David, did you slice this in CANVAS? May we see the project (mm3d.co/canvas-sharing)?

  • Avatar

    Adalyn O created an article,

    Lulzbot 1.75mm Adaptor (Mini 2)

    1.75mm Lulzbot Adaptor Installation Instruction Below are instructions to install the 1.75mm Lulzbot Adaptor. Please follow these 4 steps carefully and do not hesitate to contact Mosaic at support...

  • Avatar

    Adalyn O commented,

    Hi David, our most recent plugins for Octoprint (Palette 2 and CANVAS) are compatible with Octoprint 1.4.0. Please see the notes here: https://support.mosaicmfg.com/hc/en-us/articles/360041244214-P...

  • Avatar

    Adalyn O created an article,

    Lulzbot 1.75 Adaptors

    Print with 1.75mm filament on your Lulzbot printer with the 1.75mm Adaptor L from Mosaic Manufacturing! The 1.75mm Adaptor L allows select 2.85mm Lulzbot printers to print reliably with 1.75mm fil...

  • Avatar

    Adalyn O commented,

    Hi Magdalena, you could try slightly increasing the heat, compression and cooling. I have found that 2,0,2 or 2,1,2 for splice settings work well for most PLA, but you may find your settings to be ...