Avatar

Brandon Bloch

  • Total activity 190
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 4
  • Subscriptions 73

Activity overview

Latest activity by Brandon Bloch
  • Avatar

    Brandon Bloch commented,

    Hi Dale, There are currently no plans to be able to export painted STLs, as Canvas uses a very different approach to Meshmixer. Rather than splitting the model, the paint data is used directly by o...

  • Avatar

    Brandon Bloch commented,

    Hi Bryce, Canvas doesn't provide a setting for initial fan speed, only the setting to turn on the fan (to a specific speed) after a certain number of layers. However, it doesn't actually turn the f...

  • Avatar

    Brandon Bloch commented,

    Hi again, Just wanted to update this thread and let you know that these issues have been resolved and are now live. CANVAS should now be much more efficient about the number of transitions and ord...

  • Avatar

    Brandon Bloch commented,

    Hi all, Apologies about this issue—we understand how frustrating it is that your prints can end up using much more time and filament than is necessary. We have identified and fixed the bug that cau...

  • Avatar

    Brandon Bloch commented,

    Hi there, Chroma automatically detects and uses the same Z-lift height as your print when moving to and from the tower, similar to retractions. Thus, if you don't want any Z-lift, you should set th...

  • Avatar

    Brandon Bloch commented,

    Hi Duncan, I'm glad to report that this feature has arrived! You can now set custom GCode sequences to run before and after side transitions, and if set, these sequences fully control movement to a...

  • Avatar

    Brandon Bloch commented,

    Hey John, I would recommend primarily tuning the extrusion width for the lower raft layer until you get nice thick lines—perhaps even combining with a small negative Z-offset, as your nozzle will o...

  • Avatar

    Brandon Bloch commented,

    Hi again, Just following up to let you know this issue has been resolved. Lower raft layer values should now be applied correctly. Please let us know if you still have any issues! Cheers,Brandon

  • Avatar

    Brandon Bloch commented,

    Hi all, Apologies about this issue. We've identified a problem with the values for raft density and extrusion width being passed into the slicing engine (lower raft layer only—upper layer is workin...

  • Avatar

    Brandon Bloch commented,

    The fix for this issue has been released.