Dremel 3D45 - Tube Routing into Extruder?

Comments

3 comments

  • Avatar
    Jonny Yeu

    Hey Russ, with our 3D45's, we attach load filament with the top cover open and place the Velcro right on the extruder. You should then be able to secure the extruder clip right onto the Velcro. If you'd like to design your own clip, we have a guide on how to do this here: http://mm3d.co/p2extruder-clip

    0
    Comment actions Permalink
  • Avatar
    Russ Sarquis

    How do you run the Dremel 3d45 Printer with the top open without stopping the print? 

     

    When either of the doors are open there is a warning message displayed on the printer screen for  20-30 seconds before the print automatically pauses until after the doors are closed.

    I read somewhere that a magnet can be used to trick the door switch sensors but no idea on where to place the magnets.  Is this how you set it up or is there another way to trick the door sensors?

     

    0
    Comment actions Permalink
  • Avatar
    Jonny Yeu

    Hey Russ, yes, you can place magnets at the top right corner of the door to help avoid this issue:

    0
    Comment actions Permalink

Please sign in to leave a comment.