So I've had the palette 2 for a few weeks now and have been running calibrations virtually non stop, and still can't get a decent print. I have restarted the calibration process a few times to make sure that I am not doing anything incorrectly.
I have also done an extruder calibration to verify I am extruding the correct amount of material.
I initially was using canvas to slice but had no success so I reset the palette and now use S3D and Chroma, I print in accessory mode. I have the pings set to movement pauses for pings as I had seen that this has helped some people.
Every print I do seems to have decent ping/pong values I think. Pong is consistent at 100-101%. Ping consistently ranges from 98% to 103% occasional missed ping, but not many.
The first 2 colour Keychain print always comes out great.
So I move on to do the earbud holder as suggested. I save the values each time and can see the improvement each time.
I then tried a gradual calibration print starting at 2 colour up to 4 colours.
Again, I was happy with the improvement each time so I always saved the values. though still some bleeding into the white (slightly translucent white so hard to not get some bleed I imagine) I thought id try an actual print with a decent amount of splices.
Complete fail, all colours in the wrong place. So I tried a two colour print with a decent amount of splices,
Still a fail.
I am really stuck and dont know where to go from here.
Please sign in to leave a comment.