Chroma Splices

Comments

7 comments

  • Avatar
    Jonny Yeu

    Hey there, are you creating a new Material Profile with these Splice Tuning settings? Palette will only use the values if a Material profile is created and specific bodies are assigned these materials.

    0
    Comment actions Permalink
  • Avatar
    ss220astro

    Hi Jonny, I did not create a new profile, but changed the default soluble settings. I then assigned the first nozzle to PLA and the 2nd nozzle to soluble. That is when I got the weak splices. When I set both to the default soluble, I was able to get a decent print. When one body is PLA and the other is soluble, it seems that some splices are using the PLA setting and some are using the soluble setting.  I'm not sure what the best practice is here.

    0
    Comment actions Permalink
  • Avatar
    Roger M

    I described a similar issue here. First i thought it was my mistake, but after a retest i noticed it uses 0,0,0 for splicing instead of what i entered in Chroma.

    0
    Comment actions Permalink
  • Avatar
    Jonny Yeu

    Thanks for clarifying! I want to check that when entering the information into the Material Profile, you're setting the combination for PLA and Soluble (as found here: http://mm3d.co/p2splice-tuning ):

     

    0
    Comment actions Permalink
  • Avatar
    ss220astro

    Jonny,

    Thanks! FYI, you have some extra characters in the link above that you might want to remove so it works properly.  I'm using Chroma, so the dialog box is a little different than what is pictured.

    Bottom line, I missed the step where in the tuning section, you pick a different filament to get the dialog to specify ingoing and outgoing filaments. I see it now and will try that soon.

    As always, your assistance is greatly appreciated!

    0
    Comment actions Permalink
  • Avatar
    Jonny Yeu

    Good call! The link has been updated. Let us know how this works for you!

    0
    Comment actions Permalink
  • Avatar
    Bis25

    Did you ever figure this out?  I have the same problem with Chroma not using my splice settings.  

    0
    Comment actions Permalink

Please sign in to leave a comment.