This article is taken from Step 4a of the Palette 2 (Pro) Splice Tuning Guide, and focuses on how to enter values into CANVAS after Splice Tuning has been done.
Once you have finished splice tuning to determine what settings to use between two different types of filament, please follow the instructions below to ensure that these settings are used during your print.
- To use the Heat, Compression, and Cooling Factors found during splice tuning, open your project and proceed to the ‘Color’ screen.
- On the left menu, select a color to open the options window. Ensure that you have created material profiles for your filaments by selecting Add New Material.
- Once your materials are created, select Splice Settings. You’ll be able to select your materials and enter the Splice Tuning values in the following window:
- If the First and Second Material are the same (ex. PLA - PLA), the Heat, Compression, and Cooling factors will be the same regardless of which material is fed into Palette first. Only one set of values will be needed:
If the First and Second Material are different materials (ex. PLA - TPU), the Heat, Compression, and Cooling factors would differ depending on which material is the “pushed” (ingoing) filament versus the “standstill” (outgoing) filament. Because of this difference, the user will need to set values for both situations individually. When setting the Heat, Compression, and Cooling values, keep in mind that the ‘outgoing’ filament is being heated at a standstill while the ‘ingoing’ filament is being pushed into the molten filament, compressed, and cooled to create a splice. Once one combination has been tested, swap the filaments in drive 1 and drive 2 to test for the second scenario.
- Once your Splice Settings are set, select Save to have these settings applied to your project and future splices.
If you have any additional questions, please send a message to us at firstname.lastname@example.org.