Perfecting Calibration

Follow
Was this article helpful?
5 out of 5 found this helpful
Have more questions? Submit a request

Comments

7 comments

  • Avatar
    Neil Watts

    Thanks for this great article Jonny.  

    Stunning Benchy at the end.  What printer was used to create this?

  • Avatar
    Jonny Yeu

    Thanks, Neil! If I recall correctly, it was done on our Type A Series 1 Pro.

  • Avatar
    Neil Watts

    Thanks.  That is one remarkably clean print :)

     

  • Avatar
    Simon Young

    Does the pinging still work correctly if you are using side transitions rather than a transition tower  ?

  • Avatar
    Jonny Yeu

    Yes, pinging will still occur even when using side transitions. You should still see the ping signature occur in side transition where your extruder will pause, extrude, then pause again before continuing with the print.

  • Avatar
    Tank6919

    Why can't I find "Re-Calibrate Printer with Palette" in Chroma?

    I am in edit printer profile and have selected Palette tab but re-calibrate is nowhere to be found?

     

  • Avatar
    Jonny Yeu

    Hi Tank6919, this option is only for Palette/Palette+. If you'd like to re-calibration your Palette 2, please follow the steps here: http://mm3d.co/calibration-troubleshooting

Leave a comment