KISSlicer and Chroma Setup

NOTE: this guide assumes that KISSlicer has already been successfully configured for your printer, and that you are using KISSlicer PRO.

Configure Settings

• Profile Settings
    • Ensure “Settings Level” is set to “Expert”
    • Printer tab
        • Hardware
            • Set “Number of Extruders” to 4
        • Extruder Hardware
            • Ensure Ext #2–4 settings match Ext #1 settings
        • Ext Map tab
            • Select the same material profile for Extruder 1–4
        • Printer G-code tab
            • Ensure that the “Select new Ext & Warm” field includes only a toolchange command (e.g. “T<EXT+0>”)
            • Ensure “Warm Same Ext”, “Cool Same Ext”, and “Cool & Retire Old Ext” only contains, '; empty' and the field is not left empty
            • Dual-extruders: ensure your Prefix and Postfix don’t include any nozzle priming or temperature settings for extruders other than T0
       • Style tab
            • Ensure “Joint" is checked
       • Support tab
            • Ensure “Zgap” and “1st Zgap” are set to 0
       • Matl tab
            • Ensure “PreloadVE” is set to 0
       • Misc. tab
            • Ensure “Multiple Object Print Order” is set to “Simultaneous”

Slice Multi-Tool G-code

1. Load in ALL the STLs you would like to print in the same import
2. In the sidebar, click on the STL group that was just imported
3. Expand the Object tree so that each STL is visible
4. For each STL, click the STL to select it and select the extruder to be used to print it
5. Close the window when all STLs have been mapped to an extruder
6. That’s it! Click “Slice” and then “Save”, and you’re ready to load the file into Chroma

If you have any questions, please send us a message at support@mosaicmfg.com.