Chroma V3.1.4

Follow
Was this article helpful?
9 out of 9 found this helpful
Have more questions? Submit a request

Comments

7 comments

  • Avatar
    Jan Doubrava

    please add a feature to show only one layer in the preview!

    1
    Comment actions Permalink
  • Avatar
    Donovan Meyers

    Is this the correct location for release notes? https://support.mosaicmfg.com/hc/en-us/community/posts/360000736094-Chroma-3-is-here-

    0
    Comment actions Permalink
  • Avatar
    Jonny Yeu

    Hi Donovan, yes, this would be the location where we'll update the firmware release notes.

    0
    Comment actions Permalink
  • Avatar
    Jan Doubrava

    Chroma 3.1.3
    firmware setting - repetier
    postprocesing deletes print fan PWM settings. please fix this!

    0
    Comment actions Permalink
  • Avatar
    Jonny Yeu

    Thanks for sharing, Jan, sorry to hear that you ran into this issue. Could you please try using the the RepRap firmware setting and see if the issue persists?

     

    0
    Comment actions Permalink
  • Avatar
    Joe Bruno

    How do you get past the wizard? I have a P2 and downloaded Chroma but if you dont complete the wizard which appears to be applicable to the original Palette the program exits.

    0
    Comment actions Permalink
  • Avatar
    Jonny Yeu

    Hey Joe, the wizard will help you create a printer profile for the P2 as well, but if you'd like to bypass the wizard, you'll need to upload an existing profile. Please send me a message (jonny@mosaicmfg.com) and I can send you a Chroma test profile to bypass this setup guide.

    0
    Comment actions Permalink

Leave a comment