Palette Screen and Navigation

• Allows for multi-color prints with precise in-layer color changes.

• With Printer - Produces multi-color filament in sync with a printer's filament usage. Use this mode to produce a layer print.
• Without Printer - This mode will simply keep making filament. This is great to inspect your splice quality.

• Clear Output - Clears filament from your Palette+'s output.
• Preheat - Heats your hot tool in preparation for a print.
• Unload Inputs - Allows you to unload filament from specific drive.
• Jog - Manually push filament through any drive. Used for clearing Palette+.
• Splice Tuning - Allows you to fine-tune splicing parameters for multi-material printing.
• Diagnostics - Test to ensure all Palette+ systems are working as intended.

• Printer Calibration - Use this mode when you are calibrating your printer with your Palette+.
• Splicer Distance - This procedure checks that the position of the hot tool is correct in your Palette+.
• Steps per Count - Used when re-calibrating.
• From Config File.

• Sounds (On/Off/Menu Only) - Turns the sound of Palette+'s pings on or off.
• Ambient Heat (On/Off) - Positions the hot tool closer to the hot tube to maintain 50 degrees. If you turn this feature on, make sure it’s also on when running Splice Tuning.
• Cooling time (3-9 seconds) - Adjusts the time the splice cools after heat is applied. Default of 3 seconds.
• Extra 1st Heat (0-5 seconds) - Adds extra heat on the first splice if the splicer tube is not warm enough. You will not need this if ambient heat is on.
• File Order (Date, Name) - Arrange the order of your files.
• Logging (On/Off) - Saves text files to the Palette+ SD card which records the Ping and Pong offset history of your print.
• Reset Tube - Resets the number of splices done. This should be reset when replacing the splice block. Learn more here.

Has information on: Firmware Version, Splice Distance, SPC (Steps per Count), # of Encoders, Temperature, Opto status, Tube Length, # of Splices, Total Length, and Calibration Values.

• Ping Offsets - Last 10 Ping offset values.
• Pong Offsets - Last 10 Pong offset values.
• Filament Used - Amount of filament used per drive.

• Follow on-screen instructions to swap filament on a specified drive.

• Follow on-screen instructions to cancel a print.

• Sounds (On/Off/Menu Only) - Turns the sound of Palette+'s pings on or off.
• Extra 1st Heat (0-5 seconds) - Adds extra heat on the first splice if the splicer tube is not warm enough. You will not need this if ambient heat is on.
• File Order (Date, Name) - Arrange the order of your files.
• Reset Tube - Resets the number of splices done. This should be reset when replacing the splice block. Learn more here.

• Same as above.

If you have any additional questions, please send us a message at support@mosaicmfg.com