Bonjour @Alina, Je vous ai envoyé mes coordonnées sur l'email support@mosaicmfg.com Notez que je comprends que vous parlez du commutateur qui est dans le tampon? Vous devez savoir que je l'ai remplacé lors de la mise à niveau avec le kit 2S. Ce n'est donc plus l'original. Here are also some pictures of the installation: However, I have no way of making sure there is no elbow for the outlet tube. But the filament is not crushed or pinched there at any time. This circulates freely to the end of spinning tester then to the extruder.
Hello again, or good evening here Here is the information requested in photos: The switches seem to work (on the 2 photos 1 and 2 which are those concerned by the 2 color calibration). the 3 and 4 are also good. The value of the encoder wheel varies between -1, 0 and 1 (3 photos) The value after a 360 ° turn with my finger (therefore with low accuracy) is 2273. SPC and PPM not modified. (1 photo)
Hello, Here is what I can give you as info: 1. The Palette is up to date under version 9.2.9 2. I systematically redo the SPC and PPM calibration when I start my tests with the Palette again. The values are always within these ranges. 3. I share with you the Canvas project of the 2-color keychain (the one I pictured for you above) : https://share.canvas3d.io/projects/00f04... I also share with you the 4 colors (same photos) which did not work at all : https://share.canvas3d.io/projects/f99da... 4. I updated Octoprint last night. I did a test at the beginning of the afternoon. I'll keep you posted to follow. Update 2020-08-07 14:50 following Octoprint 1.4.2: Description of the 4 tests done this afternoon: test 1 with model -> https://share.canvas3d.io/projects/f69f0... The filament does not stop at the end of the Pallet outlet tube. Forced to stop printing manually via the pallet screen. test 2 with model -> https://share.canvas3d.io/projects/00f04... the filament stops 2cm before the end of the out tube....
(Update of 2020-08-06) I complete my explanation of yesterday, Here is a video showing the steps to start the calibration but which ends, as explained below by a filament that comes out constantly. https://video.ploud.fr/videos/watch/2360...-fc30-4229-aa63-4cdbf1cb054e
Hello Regarding the basic calibration here is what I do and what happens: 1) Reset Palette 2S (since whenever I have time to take care of it to try to make it work, I start again from the base. For info, everything is up to date (Palette 2s and Octoprint with Palette and Canvas ) and the CR10S is under Marlin 1.1.8. 2) Calibration of the SPC and PPM Palette (see photo of the last one) 3) Adjustment of the splices which I put at +2 on the compression which seems to limit the problems without eliminating them completely. 4) Creation of the Gcode in Canvas online. (I have for now abandoned the solution with Simplify3D and Chroma) 5) Send to Octoprint from Canvas 6) Starting printing 7) The pallet is calibrated for the filament length for the first printing. I therefore stop it as soon as I see the new color coming out at the end of the nozzle. (Note that since yesterday and the update of Octoprint to 1.4.1, the Palette no longer stops the output of filament before I insert it in the extruder and which comes...