Steve Worcester

@sworcester

Questions

Is there a way to reuse a stamp? February 6
If I have a sphere and I wan to stamp an object in multiple places, do I have to upload the stamp for each placement? And...
What software can simulate gradient or pattern modes? February 4
Is there a way to drag a single color model into any of the software and simulate things like gradient mode or pattern...
How do I change the color at a specific height? January 20
I have a basic rectangle lets say 50mm high, trying to have it start printing with color 1, transition to color 2 at 10mm,...
Wipe tower is 4x higher than the print January 17
Brand new, trying to print the keychain on on an MK3S, sliced it on canvas (4 colors) and it prints the 1st layer color...
Setups above an enclosure January 14
I am an MK3S in an enclosure and would like to put the Palette 2S Pro above the enclosure (upside down) and pulling...

Answer to "How do I change the color at a specific height?" January 23
I figured it out, not real intuitive, mostly because I needed to change the extruder at the desired layer height but figured it out. When I prepare in Chroma, does Chroma change any of the settings I have done with Slic3r? I noticed it has filament profiles, but I think those are only for the splicing portion
Answer to "Wipe tower is 4x higher than the print" January 18
If I load the STL into the slicer, I get these two distinct layers, would that account for the gap?