1) I don't understand how I would setup a Direct Drive printer that uses a long "reverse Bowden tube" setup, one where the Bowden tube simply guides filament from the rear to the tool head (Formbot Troodon 2.0). I understand I need Palette3 to create enough filament so it protrudes about 1" beyond the end of the bowden tube, so it can be feed it into the extruder gears. How is that reverse Bowden tube set up?
2) I don't understand how pushing filament into a direct drive extruder gears, then running manual or auto load achieves accuracy? Wouldn't I need to verify precisely when the filament starts coming out the hotend - that being a more precise assessment of when the filament is loaded? Just trying to understand. Thx in advance.
1) I don't understand how I would setup a Direct Drive printer that uses a long "reverse Bowden tube" setup, one where the Bowden tube simply guides filament from the rear to the tool head (Formbot Troodon 2.0). I understand I need Palette3 to create enough filament so it protrudes about 1" beyond the end of the bowden tube, so it can be feed it into the extruder gears. How is that reverse Bowden tube set up?
2) I don't understand how pushing filament into a direct drive extruder gears, then running manual or auto load achieves accuracy? Wouldn't I need to verify precisely when the filament starts coming out the hotend - that being a more precise assessment of when the filament is loaded? Just trying to understand. Thx in advance.