Gerald Allan Loudermilk

I keep getting ping errors during print that stop the print, I even set up a print without any splices in Prusa 2.6 Alpha 6 and P2PP and it still stopped for pings. I am not sure what is going on. I am using Ender 5S1 with Ender-S1_HW_CR4NS200141C13_SW_V1.0.5_F401_International Edition firmware. for short prints it seems ok, but a print that measures in hours, will error out for pings. The last Multi color print I did, had good splices from the tool-head all the way to where the filament entered the P3P. It still stopped for ping issues I am stumped. I thought at first it was missing splices but the last two scenarios proved it was the P3P. I was able to take control of the printer manually and was able to feed filament no issue after the print stopped with no splices. Please help!

Allan