Alex Owen

How can I extract or export ping/pong values so I can figure out how much variation I have? I have a print with several...

First time using the machine in a while and I found that after a splice and cut, the input gear was not retracting the...

My workplace’s Palette had been working relatively fine and then later that day I powered it back on and instead of...

My workplace is also experiencing this problem. It’s happened several times where short prints have been successful (or at least didn’t have the freeze-up) and some longer ones (for example, 26h) will fail. The P3P screen will freeze and become unresponsive, and it will stop producing filament. However it does not tell the printer this, and it continues going as per the Gcode just without extruding anything. There was no clog, there’s just simply no filament feeding into it. Tried to hold power button to turn it off but it didn’t work, so had to unplug. The most recent time it was very frustrating because I have numerous failures due to other settings and I’d finally got it dialed in, only to be met with this problem.