Hello! have today a problem with canvas getting only one stl file when I sliced. I have clicking Devices above project settings and turning 'Accessory' on. But still only get a stl file... this is a file with only one color. in single mode when I loaded it into canvas....
Sorry that you did not test your Firmware before the release of v22.03.29.0 this is bad it would have facilitated a lot of work fr me... i had to go back to v22.02.09.0 and it wors fine! Then to my Creality Ender 5 Plus which had everything in original I had to rebuild everything on my extruder holder nothing suited for your tube holder. And there was no USB cable that was for my printer… It is now only in the morning hours that I have been able to run my first print on keychain... i saw that the Temeraturen on the Printer is set to 210 Degrees and 60 on the bedd this is something that i can change ??, Would rather have had 200/0 on the bed works best on my printer with PLA... tried to change in P3 but it changes back with no choice to save... Kindly Christer Persson
Hello!
had a problem with canvas getting only one stl file when I sliced.
I have clicking Devices above project settings and turning 'Accessory' on.
But still only get a stl file...
this is a file with only one color. in single mode when I loaded it into canvas....
Can't print just one color why ??