and if your extruder has no plug for a bowen tube.. because its direct DRIVE!? “For the majority of Direct Drive printers, the medium length of tubing (800 mm) allows for the extruder to move around the print area comfortably. “ this is just a stupid bit of writing! Direct drive doesn’t normally have bowen tubes!
Nothing here covering direct drive where there isnt a bowen tube! Then what? Am I meant to pretend that there is one and put in the length of pla I have measured and then saved in the palette? Why doesn't this just get picked up from the measurements set in the palette? Is this why it just runs out if ola at the printers exteuder amd snaps the pla because the palettes not feeding it?
What if your direct drive does not have a connection for the tube and you measure out a length of pla to use and set that length? Shouldn’t the palette then make sure that length is always there between it and the printer?
What does this even mean? Test slicer settings for what? My printer works perfectly with out the palette s2! Why do I need to run a calibration test on my slicer settings? Am I mean to print a set file? Am I meant to print using the Pallett but just as a normal single print? If so why the !&&* isnt this in the setup guide? It says to connect every thing and print!
Well this is useless! You should provide links for what to do if it doesn't work! Like if its not feeding the pla enough to the print while trying a print! I can't find anything to tell me how to fix this!
What about cura 4.6 \ 4.7 ? same thing?
and if your extruder has no plug for a bowen tube.. because its direct DRIVE!? “For the majority of Direct Drive printers, the medium length of tubing (800 mm) allows for the extruder to move around the print area comfortably. “ this is just a stupid bit of writing! Direct drive doesn’t normally have bowen tubes!
Nothing here covering direct drive where there isnt a bowen tube! Then what? Am I meant to pretend that there is one and put in the length of pla I have measured and then saved in the palette? Why doesn't this just get picked up from the measurements set in the palette? Is this why it just runs out if ola at the printers exteuder amd snaps the pla because the palettes not feeding it?
Cant find this mode and theres no way these setting work..closer to 4.3.1
What if your direct drive does not have a connection for the tube and you measure out a length of pla to use and set that length? Shouldn’t the palette then make sure that length is always there between it and the printer?
Ahould all products be flashed to the newest firmware? I just got mine! Do I have to do this anyway?
What does this even mean? Test slicer settings for what? My printer works perfectly with out the palette s2! Why do I need to run a calibration test on my slicer settings? Am I mean to print a set file? Am I meant to print using the Pallett but just as a normal single print? If so why the !&&* isnt this in the setup guide? It says to connect every thing and print!
Well this is useless! You should provide links for what to do if it doesn't work! Like if its not feeding the pla enough to the print while trying a print! I can't find anything to tell me how to fix this!