Dan D'Attilio

@hitsujioyaji

Questions

Help - I am not receiving pings no matter what I do Feb 14, 2022
Hi, I had to change my extruder calibration so I reset my Palette 2 Pro to factory. Then, I ran calibration print which...
Help! not enough filament from Palette to finish print Feb 9, 2022
Have tried everything that I can think of to synchronize Palette 2 Pro with Ender 5 Pro. Keychain prints no problem but...
Palette 2 Pro ended print abruptly - printer extruding too much? Feb 6, 2022
Hi All, I feel like I am getting closer to actually finishing a print other than the keychain (earphone case). This time I...
Color transitions happening at wrong times -- missing pings the reason Feb 4, 2022
Was able to print two perfectly good key chain calibration prints. I then started printing my own model only to find that...
How to control # of layers of raft in Canvas Feb 3, 2022
Anyone, is there any way to control the number of layers in a raft in Canvas as one can do in Cura. I usually use 3 layers...
Have to reload filament if printing the same print? Feb 3, 2022
All, do I have to unload the filament after a print if I plan on printing the same print again?
Load filament faster on Ender 5 from Palette 2 Pro Feb 3, 2022
The extruder on my Ender 5 Pro moves the filament very slowly when loading filament. The Change Filament function moves it...

Event	Count	Delta
Accepted answer	4	40
Post was voted up	2	24