Introduction
The instructions below are in the rare instances where a switch needs to be replaced. Please note: Each homing switch is connected to the electronics tray through a wire. When removing the switch, please secure the wire by holding it or taping it to the substructure so that the wire does not fall through the opening. If the wire does fall through and you're unable to retrieve it, please follow the instructions at mm3d.co/bottom-casing to remove Palette 2's back plate.
Tools
Parts
Video Overview
-
-
Turn Palette 2 off and remove the top lid by gently lifting from the sides.
-
With the top lid removed, remove the acrylic plate covering the switches by loosening the thumbscrews counterclockwise.
-
Once you have access to the switch, remove the screw holding the switch to Palette 2's casing.
-
-
-
Position a tool (such as a screwdriver, pliers, etc.) under the switch to lift it up and out of Palette 2. The switch will be connected to a wire which can be disconnected, but be careful to secure the wiring so that it does not fall into the casing.
-
Replace with a replacement switch. The wiring will only fit in one orientation.
-
There is a locating pin that needs to be pushed into the hole before replacing the screw. Set the switch back down and replace the screw.
-
If you have any additional questions, please send us a message at support@mosaicmfg.com.
If you have any additional questions, please send us a message at support@mosaicmfg.com.
Cancel: I did not complete this guide.
3 other people completed this guide.
2 Comments
Hi I still have the 2s palette, I can't complain because I've used it a lot with satisfaction, the only not insignificant flaw is that it is quite slow in its work, unfortunately the unpleasant thing is that lately during a job the homing microswitch in the central part was damaged and I am forced to order it from you in order to restore it with the various problems due to customs that greatly increase the price, is there a cheaper way? No distributor in Italy?
Ciao Gionata, grazie per il tuo messaggio. Inviaci un'e-mail a support@mosaicmfg.com e possiamo inviarti interruttori sostitutivi gratuitamente. Apprezziamo il tuo continuo supporto!
Hi Gionata, thanks for your message. Please send us an e-mail at support@mosaicmfg.com and we can send you replacement switches for free. We appreciate your continued support!