Introduction
This guide will take you through setting up KISSlicer to work with Chroma and Palette.
Note: This guide assumes that KISSlicer has already been successfully configured for your printer, and that you are using KISSlicer PRO.
-
-
Profile Settings: Ensure Settings Level is set to "Expert"
-
Printer Tab:
-
Hardware: set Number of extruders to 4
-
Extruder Hardware: ensure Ext #2-4 settings match Ext #1 settings
-
Ext Map tab: select the same material profile for extruder 1-4
-
Printer GCode tab:
-
Ensure Warm Same Ext, Cool Same Ext, and Cool & Retire Old Ext only contains, '; empty' and the field is not left empty
-
Ensure that the Select New Ext & Warm field includes only a toolchange command (e.g. “T<EXT+0>”)
-
-
-
Dual-extruders: ensure your Prefix and Postfix don’t include any nozzle priming or temperature settings for extruders other than T0
-
Style Tab: ensure "Joint" is checked
-
Support Tab: Ensure “Zgap” and “1st Zgap” are set to 0
-
Matl Tab: Ensure “PreloadVE” is set to 0
-
Misc. tab: ensure “Multiple Object Print Order” is set to “Simultaneous”
-
-
-
Load in ALL the STLs you would like to print in the same import
-
In the sidebar, click on the STL group that was just imported
-
Expand the Object tree so that each STL is visible
-
For each STL, click the STL to select it and select the extruder to be used to print it.
-
Close the window when all STLs have been mapped to an extruder.
-
That’s it! Click Slice and then Save, and you’re ready to load the file into Chroma.
-
If you have any questions, please contact us at support@mosaicmfg.com.
If you have any questions, please contact us at support@mosaicmfg.com.
