Skip to main content

v1.1

Minor Versionm

by Frank Rupert Catapang

Introduction

If filament slips out of the track around the metal roller bearings and gets driven into an unconstrained area of Palette, it can be caused by very strong or sharp filament. If the tip of the filament is very sharply bent, it can either jam at the incoming Teflon section of the outgoing drive, or miss this section entirely and continue to be driven into an unconstrained area of Palette.

  1. Turn on your Palette. Insert a filament into Drive 1.
    • Turn on your Palette. Insert a filament into Drive 1.

    • Access the menu and select Manual control > Jog mode > Drive 1 with outgoing drive.

    • Manually spin the dial so that it pushes the filament all the way through your Palette, which will push the piece out the exit tube.

    • Once this is complete, reverse the spin of the dial and "jog" the filament back out of Drive 1.

Conclusion

If you have any additional questions, please send us a message at support@mosaicmfg.com

Mosaic Support

Member since: 04/02/2020

1 Reputation

0 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 9

All Time: 13

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.