Skip to main content

v1.1

Minor Versionm

by Frank

Introduction

This issue occurs when you are first feeding filament into Palette/Palette+ during the startup sequence. When this happens, you hear a number of clicking sounds, and the filament does not feed in any further.

The cause is likely a bend in the filament, getting caught on the ingoing drive of Palette/Palette+.

  1. Plug the power supply in and turn on Palette/Palette+. Access the menu and select Manual control > Jog mode > Drive 1 with outgoing drive.
    • Plug the power supply in and turn on Palette/Palette+.

    • Access the menu and select Manual control > Jog mode > Drive 1 with outgoing drive.

    • Manually spin the dial so that it pushes the filament all the way back out of your Palette/Palette+.

    • Once you have done this and the filament is out of your Palette, straighten the filament with your hands, and feed it back into your Palette.

Conclusion

If you have any additional questions, please send us a message at support@mosaicmfg.com

Mosaic Support

Member since: 04/02/2020

155 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 51

Contact Mosaic Support Team

© 2023 Mosaic Manufacturing Ltd.