In Canvas 6 hours work but importing g-code it is 12 hour work
so what must i fill in to Canvas to optimize my snapmaker 2.0.
Is this a good question?
Rep: 1
so what must i fill in to Canvas to optimize my snapmaker 2.0.
Rep: 10.4k
Hey @ivan45, thanks for reaching out about this. Could you please share this Canvas project with us so we can take a look at the generated GCode on our end (instructions here)? Thanks!
Comments:
Hey Ivan, thanks for sharing that. It looks like the print time for this project is only about 30 minutes - was this the correct project? Some suggestions for reducing print time are increasing print speed to 50 mm/s, using infill for transitioning, and printing multiple models in the same project.
by Alina
sorry this was the wrong project. https://share.canvas3d.io/projects/b0dfa...
No problem, thanks for sending that over. I was able to reduce the print time by approximately 1 hr by increasing your perimeter speed to 50 mm/s and using infill for transitioning. You can also check out this helpful article on other tips and tricks you can try to reduce it even further: https://3dprinterly.com/8-ways-how-to-sp...
by Alina
Past 24 Hours: 2
Past 7 Days: 9
Past 30 Days: 11
All Time: 72