Skip to main content

The newest generation of Palette, the multi-material solution for 3D printing. Resources for Palette 2, Palette 2 Pro, Palette 2S, and Palette 2S Pro.

107 Questions View all

I think either I have a lemon or this is crap

Attached is a picture of Keychain number 8. Yes 8. So far I have had 0 that have been successful. The palette is not generating enough filament to finish the print. I have a direct drive machine. I started with the exact distance from the gears to the nozzle in the printer profile at 80mm. I have increased that to 200. Each increase is causing me to run out of filament sooner than the last. The area inside the black are missing filament.

Before you tell me, yes my extruder is calibrated. Yes the bed is level. That is not the issue. The issue is with the the palette and/or the slicer.

If I could return this, I would. As it stands right now I am extremely unhappy. This is crap.

Block Image

Ping From 7:

Ping 1 100.74%

Ping 2 100.35%

Ping 3 100.11%

Ping 4 100.34%

Ping 5 100.35%

Ping 6 100.29%

Ping from 8:

Ping 1 99.93%

Ping 2 99.9%

Ping 3 99.92%

Ping 4 99.98%

Ping 5 100.02%

Ping 6 99.81%

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

2 Answers

Hey @jd2112, could you please try the earbud holder next instead of the keychain? You do not have to reset to factory defaults before trying this earbud.

Was this answer helpful?

Score 0
Add a comment

Have already reset to factory defaults.

Was this answer helpful?

Score 0

Comments:

Hey Jim, could you go ahead and do another keychain just to complete calibration and then try out the earbud holder? Please post photos of this print, along with the ping data.

by

Add a comment

Add your answer

Jim Smith will be eternally grateful.
View Statistics:

Past 24 Hours: 2

Past 7 Days: 18

Past 30 Days: 74

All Time: 74

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.