Skip to main content

Splicing profile calculates 2 days, 5 hours to print

I have a project that looks very simple, but looks like there is no way in which I can get the print times down to even under 12 hours.

1) How can I set the distance between support lines?

2) How do I change the support formation?

3) Is it possible to just use the printers own settings to do the support instead of the Canvas splicing?

4) is it possible to do each colour at 3 or 4 layer intervals?

1st colour Red build up to 3 layers high, then 3 layers printed with another colour, building up to same height level.

Block Image

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey Stephen, could you share this CANVAS project (instructions here: mm3d.co/canvas-sharing) with us? We can take a look and let you know what settings you can change to lower the print time. Thanks!

Was this answer helpful?

Score 0
Add a comment

Add your answer

Stephen Cook will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 7

Past 30 Days: 32

All Time: 32

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.