Skip to main content

The newest generation of Palette, the multi-material solution for 3D printing. Resources for Palette 2, Palette 2 Pro, Palette 2S, and Palette 2S Pro.

111 Questions View all
Discussion Topic

better adhesion of colors on the key chain calibration print

Block Image

My setup Ender 3pro w/ ender extender kit, microswiss dd, pla, palette 2s pro, canvas hub

After some frustration I finally got the 2spro to print the key chain. The base layer printed great (yellow), but the red and blue triangles on the top of the key chain didn’t stick to yellow base of the key. I’m wondering if this is operator error, some sort of G-code issue, or bad PLA.

Block Image

Reply to discussion Subscribe to discussion

Is this a worthwhile discussion?

Score 0
Add a comment

1 Reply

Hey @highyield, thanks for reaching out about this. Could you share this Canvas project with us (instructions here)? Please make sure to share the model, as well as the printer profile. Thank you!

Update (03/03/2021)

Hey @highyield, thanks for sharing that. Please delete this project and reimport the keychain, but this time please make sure to import both the STL’s in the folder (the keychain is multi body). Then, please drag one of the coloured circles onto one of the STL filenames in order to make it dual coloured. The keychain should not be painted, and should not be in more than two colours (mm3d.co/firstprint). Let us know if you have any questions about this!

Was this reply helpful?

Score 0

Comments:

ok I will give that a try, thank you

by

No problem Timothy, please let us know if you run into any other issues.

by

Add a comment

Join the discussion

Timothy M Weber will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 4

All Time: 30

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.