Skip to main content

Error 102 after Upgrade to Palles 2-S

I upgraded my Pallet just now. Everything runs nice, Calibration worked fine. But I just wanted to start a print in Multi Spool Mode as I have a lot of quite short restpieces of filament. But after selecting the material, I get a Error 102 and a reset. HELP!

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey @rolandj, thanks for reaching out about this and sorry for the trouble. Can you please reach out to about this issue and provide your shipping information? It is likely we will have to send you a replacement part. Thanks for your patience with this.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Roland Jacobsen will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 8

All Time: 17

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.