Skip to main content
Discussion Topic

Splice PLA <> PETG setting

I see the official documentation for same materials e.g. PLA <> PLA or PETG <> PETG but has anyone tested PLA <>PETG/PETG<>PLA? I was thinking of printing in PETG but going the supports in PLA.

Reply to discussion Subscribe to discussion

Is this a worthwhile discussion?

Score 0
Add a comment

1 Reply

Hey @winjet1, thanks for reaching out about this. While PLA and PETG don’t bind together very well, you can use PLA for supports and PETG for the print. You can take a look at this thread here (it’s on our FB group, so you may have to join) where multiple users did this successfully.

Was this reply helpful?

Score 0

Comments:

Thanks for the heads up. I've asked on that thread what the splice settings were to give it a try.

by

Add a comment

Join the discussion

David Koerth will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 42

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.