Skip to main content

My palete 2s pro when start printing

the palete keep fiding without stopping…

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey @eshchari, if Palette is feeding filament non-stop, this is likely an issue with your homing switch (switch right below the splice core). You can test the health of your switch by going to settings -> about -> next -> next and see if it says “pressed” when there is filament on it versus “not pressed” when there is no filament on it. Please send us an email to support@mosaicmfg.com with your shipping address and we can send you a replacement switch ASAP.

Was this answer helpful?

Score 0
Add a comment

Add your answer

eshchar ilan will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 26

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.