Cr 10S Pro using Tiny machines Firmware calibrates then sits at last calibration point, with message “Purge Extruder” with no purging happening at the Progress bar proceeds to 100% with no actual printing.
Is this a worthwhile discussion?
Hey @hewbo, thanks for reaching out about this. Is this during the keychain calibration print? Did the print begin at all? If not, can you make sure that the filament is caught within the gears of your extruder? Sharing your keychain Canvas project (instructions here) would also be helpful. Thanks!
Was this reply helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 39
